Carbon Steel 90 Degree Elbow for HVAC Systems

Product Overview

Spun carbon steel 90-degree elbows go into heating, ventilation and air-conditioning pipework. Ends are prepared for butt weld, thread or socket weld depending on the riser layout, so an HVAC contractor pulls the version that drops straight into the run. The spinning die gives the barrel a smooth outer surface, which is why the insulation wraps tight without a lumpy seam.

A box clears the floor in the standard cycle, and the piece price band runs US $2 to US $150. The bend drops an air-handler connection, a riser or a plant-room rack around a duct, which is how it suits a ceiling void packed with services.

Key Features

Butt-weld ends suit the chilled-water riser; threaded ends the small condensate drain; socket-weld ends the branches a fitter reaches above a ceiling. The carbon body paints well once the insulation goes on, which is how it holds up in a plant room that cycles hot and cold.

Each carton is labelled with bore, wall and end form before it leaves, and the elbows are oiled to stop rust during the sea leg. Ten pieces is the smallest release, which suits an MEP spares shelf rather than a whole-floor buy.

Specifications

Hot Tags: Carbon Steel 90 Degree Elbow for HVAC Systems, China Carbon Steel 90 Degree Elbow for HVAC Systems manufacturers, carbon steel industrial piping components, carbon steel pipe fitting, carbon steel pipe joint fittings, carbon steel process fittings, carbon steel threaded connector fittings, Seamless Carbon Steel Elbow